The preparation methods of activated carbon include physical method, chemical method, microwave radiation method, etc.(1) Physical method.[url=www.chinactivecarbon.com/]chinactivecarbon.com[/url] Physical method is to use carbon dioxide, water vapor or the mixture of both as activator, the carbonized carbon material and gas in the activation furnace at 500~1200℃ for carbon activation reaction, so that the pore size of the carbonized material to expand, the formation of activated carbon with porous microcrystalline structure.Gas activation method mainly includes carbonization and activation engineering.The so-called carbonization, refers to the low temperature (about 500℃) is small, the volatile coal tar molecules in the material and the thermal decomposition and curing process of asphalt, that is, to remove the volatile in advance, made suitable for the next step of activation with carbonization.When the adsorption time is 85 min, take n-600), and the calculated theoretical curve is shown in FigureIt can be seen from the figure that the measured curve is in good agreement with the theoretical curve.Fig. 2 is the simulation result of the total number of Y taken out over time after activated carbon adsorbs 1 radon atom from the environment every second and continues to adsorb for 3 days.After the activated carbon was taken out, the total number of V reached the maximum after t time, and then the total number became smaller. After about 50 min, the total number of V decreased by a negative exponential function.
The curve can be divided into a stationary area and a measuring area. The width of the stationary area the duration of the stationary area) is set at (t+50) min, followed by the measuring area.[url=www.coconutactivatedcarbon.com/]yrd coconut carbon[/url]
There is no obvious rule of counting in the standing zone. Should be avoided during this period of time.Total number of;The measurement area is counted byIts adsorption is selective, and non-polar substances are easier to be adsorbed than polar substances.In the same series of substances, the higher the boiling point of the substance, the more tolerantEasy to be adsorbed, the greater the pressure, the lower the temperature, the greater the concentration, the greater the amount of adsorption.On the contrary, decompression and heating are beneficial to gas desorption.It is often used for gas adsorption,Separation and purification, recovery of solvents, decolorizing agents for sugar solution, grease, glycerin, medicine, deodorant for drinking water and refrigerators, filter agent for gas masks,It can also be used as a catalyst or metal salt catalyst carrier.Early production of activated carbon raw materials for wood, hard nut shell or animal bones, later mainly used coal, after drying